Well the injury is somewhat healed and I can take the big bandage off. Still don’t have much feeling in the top third of that finger, but the doctor believes its going to heal close to 100%, so I’ll take that! Now its time to start working on the next project, which involves laminating …
One of the issues with any sort of hand labor (carpentry, automotive, etc.) is there is a danger from the tools you use. You need to always be on guard, especially with powered equipment (like Table saws, miter saws, etc.). Whenever I’m working with powered equipment, I make sure the guards are on, and I …
I received a commission at the last farmer’s market that I attended. A local vendor, Kathy Steinfeld from Controlled Burned Designs, wanted a small tabletop for her sewing table (36″ x 20″). I was able to take on the work, and just got started with the build. Its going to have breadboard ends to help …
After a lot of dovetailing, measuring, cutting and gluing up, the joinery bench top is pretty much done (still need to do some planning and sanding to clean it up). It’s got a nice Moxon vise for the front to do dovetailing, cutting tenons, etc. I’ve also got a small “tool well” in the back …
Well, the next project is a joinery bench for the shop, which will enable me to do certain work up high, where its easier to see and cut/chisel/adjust. Think Dovetails, carving, etc. To make the workbench top, I’ve had to joint two faces (make them flat and square to each other) plane them down to …
Creating the laminated top for the joinery bench Read More »
I finally completed the Stickley #74 book racks (soon on the project page, available to order). Now its time to get started on the next project. I’m going to be building a small, semi-portable joinery bench, which I can take to craft shows and use for cutting dovetail joints and carving. Its based on a …
Completed cleaning up the Tenons and test fitting them into the shelves. I have to make each one separate, as the mortises and tenons need to match and there are always minor variations. So I use chisels and a rasp to cleanup and fit each tenon for its individual mortise slot. It needs to go …
For the latest project (based on the Stickley #74 book rack) I’ve got the through-mortises cut. Now its time to mark out and cut the tenons. There are a total of eight (8) tenons for each book rack (two per top shelf, and four for the bottom shelf). They’ll all be held in place by …
Its always interesting to start a new project or developing a new product. You do a lot of research and try to determine what is selling, what materials, tools and steps are needed to produce it, and how long that is going to take. Finally, you decide on an item and you “give it a …
